4.3
IGBT驱动负栅极电源电压的变化
IGBT模块开通过程的影响
类似于
IGBT的关断过程,变化的负栅极电压主要会影响开通过程的延迟时间。反向恢复电流的di/dt,及dv/dt保持在同一水平。转载请注明出处
http://www.igbt8.com
The manufacturer often recommends the use of negative gate voltage to safely turn-off and block IGBT modules. In areas with nominal currents less than 100tA the negative gate voltage is often omitted for cost reasons. The following paper describes special considerations for a unipolar drive of IGBT modules.
Max(C2): 26.25, Max(C3): 203A, Max(C4): 383V
Figure 39: IGBT turn-on with VGE,min = -8V
Max(C2): 24.58V, Max(C3): 200A, Max(C4): 383V
Figure 40: IGBT turn-on with VGE,min = 0V
作者:Jackie Zhao